Tilt the television mounted on a table stand...
1. Press
LIST
, then
or
to bring up
STAND
in the BeoRemote One display
and press the
centre
button.
2. Press
or
to tilt the television.
To use the motorised floor stand or wall bracket function, you have to calibrate the floor
stand or wall bracket first. For more, press the
red
button in the on-screen help and find
'
Stand settings
'.
Daily use of sound modes and speaker groups
You can extend your television into a surround sound system by adding BeoLab
loudspeakers and subwoofers.
When you switch on a source, the television automatically selects the appropriate
sound mode for the source you are using. However, you can select another sound
mode at any time.
Also, when you switch on the television, the TV speaker group is selected
automatically. However, you can always select another group of activated speakers if
you want to listen to music without having to sit in front of the television, for example,
when you sit at the dining table or in an armchair.
You can adjust the settings of the sound modes and set up speaker groups. For more
information about sound modes and speaker groups, press the
red
button in the on-
screen help and find '
Sound modes
' and '
Create a speaker group
'.
Select a sound mode
You can select the sound mode that suits the source you are using.
1. Press
LIST
, then
or
to bring up
SOUND
in the BeoRemote One display
and press the
centre
button.
2. Press
or
to highlight the sound mode you want and press the
centre
button.
3. Press
or
to step between modes.
4. Press
to remove
SOUND
from the display.
When you configure a source, you can set a sound mode to be selected automatically
each time you switch on the source. For information about preset selection, press the
red
button in the on-screen help and find '
Create a speaker group
'.
Select a speaker group
Select the speaker group that suits your listening position.
1. Press
LIST
, then
or
to bring up
SPEAKER
in the BeoRemote One display
and press the
centre
button.
2. Press
or
to highlight the speaker group you want and press the
centre
button. The selected speakers cut in automatically.
3. Press
or
to step between groups.
4. Press
to remove
SPEAKER
from the display.
When you configure a source, you can set a speaker group to be selected automatically
each time you switch on the source. For information about preset selection, press the
red
button in the on-screen help and find '
Create a speaker group
'.
26
Summary of Contents for BeoVision Avant-55
Page 1: ......
