1. Press
, highlight
Settings
and press the
centre
button.
2. Highlight
Wireless and Networks
and press
.
3. Highlight
Wired or wireless
and press
.
4. Highlight
Connect to network
and press the
centre
button.
5. Select
WPS with PIN code
.
6. Write down the 8-digit pin code shown on-screen and enter it in the router
software on your computer. See the guide for the router on where to enter the
pin code in the router software.
7. Select
Connect
to make the connection.
8. A message will be shown when the connection is successful.
When operating your television, you may need to use different pin codes other than the
pin code described here. Pin codes are used for protective reasons, due to mandatory
requirement from providers and by external equipment. It may be easier for you if you
choose the same code for different systems when possible.
Troubleshooting
Wireless network not found or distorted;
Microwave ovens, DECT phones or other wireless 802.11b/g/n devices in your
proximity might disturb the wireless network.
Make sure that the firewalls in your network allow access to the television's
wireless connection.
If the wireless network does not work properly in your home, try the wired
network installation.
Internet does not work;
If the connection to the router is fine, check the router connection to the
Internet.
The PC and Internet connection are slow;
See the guide for your wireless router for information on indoor range, transfer
rate and other factors of signal quality.
Use a high-speed (broadband) Internet connection for your router.
DHCP;
If the connection fails, you can check the DHCP (Dynamic Host Configuration
Protocol) setting of the router. DHCP should be switched on.
Your television supports 2.4 GHz and 5 GHz. For more information, contact your Bang &
Olufsen retailer.
See network information
You can see information on your network connection in the
View network settings
menu.
Note: A previously well-functioning setup may develop problems over time as
surroundings change. Check your Ethernet connection or router. If the problem persists,
contact your Bang & Olufsen retailer.
Configure your network
In the
Network configuration
menu, you can select between a
DHCP
or a
Static IP
network setup.
If
Network configuration
is set to
DHCP
,
IP address, netmask, gateway and DNS servers
are assigned automatically. Otherwise, select
Static IP
to set up the network manually.
56
Summary of Contents for BeoVision Avant-55
Page 1: ......
