19
> If necessary, press
ss
or
tt
to select the options
that correspond to what you have connected to
the V.TAPE socket.
> Press
▲
or
▼
to step between menu items:
V.TAPE and AV.
> Press
GO
to store this setup.
Register extra equipment before
auto tuning
If a video tape recorder, decoder or any other
extra equipment is connected to your
BeoVision MX 8000, the connection is
detected by BeoVision MX 8000. You are given
an opportunity to check and confirm the
registration of the equipment involved.
CONNECTIONS
store
GO
V. TAPE
V. TAPE
AV
DECODER
When the STAND ADJUSTMENT menu
appears…
> Make sure that there is enough room for the
television to turn to the right and left.
> Press
GO
to start stand adjustment.
> If the adjustment is interrupted the text
‘ADJUSTMENT FAILED’ appears on the screen.
Remove obstacles preventing the television from
turning, and press
GO
to start adjustment again.
> Once adjustment is complete, the text
‘ADJUSTMENT OK’ appears and then the
STAND POSITIONS menu appears.
> To store a stand position for when BeoVision
MX 8000 is switched on, press
ss
or
tt
to turn
BeoVision MX 8000 and place it according to
your viewing position.
> To store a stand position for when the television
is switched to standby, press
▼
to move to
TV STANDBY.
> Press
ss
or
tt
to turn BeoVision MX 8000 and
place it as you wish.
> Press
GO
to store your positions.
Determine the centre position for
the television
If your BeoVision MX 8000 is equipped with
the optional motorised stand, the
STAND ADJUSTMENT menu will appear on the
screen. Once the centre position has been
determined, you can select your favourite
positions for when the television is switched
on and in standby.
STAND ADJUSTMENT
CENTRE POSITION
adjust
GO
ADJUSTING . . .
NOTE! Refer to the chapter
Settings for TV
position
on page 26 for further information on
stand positions.
