Service Mode 2.5
Activation
. Disconnect DVD 2 from the mains
2. Connect Service Cable from P03 on PCB02 to COM port
3. Open HyperTerminal
. Power on DVD 2 and confirm the following ‘read out’ in the HyperTerminal window:
Factory Diagnostics and Service Software
DVD Video Recorder (Sep 28 2006, 8:29:6)
Version :388 Build :20060928_82
Release :SG_ Buildtype :dev
Baseline :SGP29atl#SG__20050609_base Variant :sxc
DS:>
Usage
The commands that can be given are the numbers of the nuclei. A command must
be terminated with an <ENTER> character from the control PC. When typing
commands, the backspace key can be used to make corrections. Apart from this,
the Up and Down arrows can be used to browse through previous commands.
When non-supported commands are entered, the interface returns to the
command prompt line DS:>
E.g.
DS:> 888
DS:>
If the command (the nucleus number) is recognised, the nucleus is executed.
Result and output of an activated (and terminated) nucleus will be sent back to
the control service PC.
Example in case the command is correct:
DS:> 200
20000: Hardware ID = 0x27
Test OK @
DS:>
Example in case there is an error in the communication:
DS:> 00
0002: Communication with PCB0, Analog fails
Error @
DS:>
Summary of Contents for DVD 2
