FITTING AND / OR REPLACING BATTERIES
Warning
The toy of the walker frame requires 2X”AA” 1.5 Volt alkaline type batteries (not
included).
•
Batteries must only be fitted by an adult.
•
To fit and/ or replace batteries: loosen the screw on the battery
compartment cover with a suitable screwdriver, press the tab and remove
the battery compartment cover. Then remove the spent batteries and fit
new ones, ensuring that they have been fitted in the correct polarity, as
shown inside the battery compartment. Replace the battery cover and
tighten the screw.
• Always keep batteries and tools out of reach of children.
• Always remove spent batteries from the toy to avoid the danger of
possible leakage from the battery damaging the product.
• Always remove the batteries if the toy will not be used for a long period.
• Only use alkaline batteries of the same type of equivalent to the type
recommended for the correct function of this product.
•
Never mix new and old batteries, or different types of batteries.
• Do not burn or dispose of used batteries into the environment.
•
Dispose of used batteries at an appropriate differentiated collection point.
• Do not short-circuit the battery terminals.
• Do not attempt to recharge non-rechargeable batteries: they might
explode.
• The use of rechargeable batteries is not recommended and cannot be
used.
PRODUCT CARE AND MAINTENANCE
• Check regularly the walker frame for signs of damage or wear.
• Clean the plastic parts, including the stoppers, with a damp cloth.
• Clean the seat with brush or family soap and neutral scour
• Dry the metal parts to prevent the formation of oxidation.
• Prolonged exposure to direct sunlight may cause the fabric to fade.
