Banner American BA-EN45, Operating Instructions Manual

IX. Maintenance/Service...

Always use caution when servicing your laminator.

Precautions:

Disconnect the power supply and open the panel breaker
before attempting to service or repair the laminator.

Any maintenance or service should be preformed only by those
having appropriate technical training and experience.  Contact
the manufacturer at 909-296-9780 for training information or
technical assistance.

Adjust only those controls that are specified in these operating
instructions.

Cleaning Rubber Rollers:

Excessive build-up of adhesive on the rollers may cause poor lamination quality and erratic film movement.
Use the following procedure to remove any adhesive from the laminating rollers.

1. Turn the HEATED ROLLERS off and 

allow the laminator to cool

.

2. Cut the film where it comes off the top and bottom supply rolls.  Pull any film out of the laminator and away
from the rollers.

3. Carefully remove the feed table to access the rollers.  The feed table exposes hot and moving parts.

4. Disconnect the power supply.

5. Clean the exposed section of the rollers with a soft cloth dampened with an appropriate cleaning solution
such as isopropyl or denatured alcohol.

6. Reconnect the power supply and turn the FORWARD/REVERSE switch to the FORWARD position.
Turn the MOTOR switch to the ON position momentarily to expose a new section of the rollers.

7. Repeat steps 3-5 until the rollers are thoroughly clean.

8. Allow the rollers to dry completely before rethreading the laminating film.

Removing Wrap-Arounds:

Build-up on the rollers may cause a film wrap-around, especially when using thin film gauges.  Follow the
procedure below to remove wrap-arounds.

1. Turn the HEATED ROLLERS OFF.  Allow the laminator to cool.

2. Cut the film where it comes off the top and bottom supply rolls.

8