6 Device Configuration
6.1 Automatic Setup
To begin configuration, the reader must be correctly mounted at the correct reading distance for your application so that its
Field of View covers the application reading area.
Note: For Manual Adjustable Focus models go to
Advanced Setup for Manual Adjustable Focus Models
on page 46.
Automatic Setup provides an automatic procedure for setting optical/illumination and code definition parameters to obtain
the most stable decoding conditions for a single code symbology based on the images presented to the reader. It can be
set to include Image Filters if necessary. See the table below for codes and filters managed by Automatic Setup. Automatic
Setup is especially useful for DPM applications.
Enabled 1D Codes
Enabled 2D Codes
Enabled Filters
Code 128
EAN 128
Code 39
Code 93
Codabar
PDF417
MICRO PDF417
GS1 DataBar
GS1 DataBar Stacked
GS1 DataBar Limited
GS1 DataBar Expanded
GS1 DataBar Expanded Stacked
UPCEAN Family EAN13
UPCEAN Family EAN8
UPCEAN Family UPCA
UPCEAN Family UPCE
Data Matrix ECC 200
QR
Micro QR
Aztec
MAXICODE
DOTCODE
Erode 3×3, 5×5 and 7×7
Dilate 3×3, 5×5 and 7×7
Smoothing
1. Click Open Device Configuration. The Open Device Configuration window opens showing the list of
configurations (jobs) currently saved on the device. For new devices, the only saved configuration is the Default
configuration.
2. Click OK. The device enters continuous mode and begins acquiring images.
3. Place the application code in front of the reader at the correct application reading distance.
4. If needed, focus the reader on the code.
5. After the code is positioned, click Pause to stop image acquisition.
Note: If the image display area is too dark to see the images being captured, drag the Gain and
Exposure Time sliders to the right to increase visibility. This will not affect Automatic Setup.
Figure 51. Gain and Exposure Time
ABR 7000 Series Barcode Reader
42
www.bannerengineering.com - Tel: + 1 888 373 6767