background image

Omni-Directional Dome Antennas

Models

Frequency

Description

Connection

List Price

BWA-9O2-001

900 MHz

2 dBi, 18-inch cable

1/2" SS NPT Port

$140

BWA-9O2-002

2 dBi, 18-inch cable

3/4" SS NPT Port

$140

BWA-2O2-001

2.4 GHz

2 dBi, 18-inch cable

1/2" SS NPT Port

$140

BWA-2O2-002

2 dBi, 18-inch cable

3/4" SS NPT Port

$140

Warnings

Antenna Installations. Install and properly ground a qualified surge suppressor when installing a remote

antenna system. Remote antenna configurations installed without surge suppressors invalidate the manufacturer's

warranty. Keep the ground wire as short as possible and make all ground connections to a single-point ground system to

ensure no ground loops are created. No surge suppressor can absorb all lightning strikes; do not touch the SureCross

®

device or any equipment connected to the SureCross device during a thunderstorm.

Exporting SureCross Radios. It is our intent to fully comply with all national and regional regulations regarding radio

frequency emissions. Customers who want to re-export this product to a country other than that to which it was

sold must ensure the device is approved in the destination country. A list of approved countries appears in the

Radio Certifications section of the product manual. The SureCross wireless products were certified for use in these

countries using the antenna that ships with the product. When using other antennas, verify you are not exceeding the

transmit power levels allowed by local governing agencies. Consult with Banner Engineering Corp. if the destination

country is not on this list.

Violating Warnings. The manufacturer does not take responsibility for the violation of any warning listed in this

document. Make no modifications to this product; any modifications to this product not expressly approved by Banner

Engineering could void the user’s authority to operate the product. All specifications published in this document are

subject to change; Banner reserves the right to modify product specifications or update documentation at any time. For

the most recent version of any documentation, refer to: 

www.bannerengineering.com

©

 2006-2014 Banner Engineering

Corp. All rights reserved.

Banner Engineering Corp. Limited Warranty

Banner Engineering Corp. warrants its products to be free from defects in material and workmanship for one year following the date of shipment. Banner Engineering Corp.

will repair or replace, free of charge, any product of its manufacture which, at the time it is returned to the factory, is found to have been defective during the warranty

period. This warranty does not cover damage or liability for misuse, abuse, or the improper application or installation of the Banner product.

THIS LIMITED WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES WHETHER EXPRESS OR IMPLIED (INCLUDING, WITHOUT LIMITATION,

ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE), AND WHETHER ARISING UNDER COURSE OF PERFORMANCE, COURSE

OF DEALING OR TRADE USAGE.

This Warranty is exclusive and limited to repair or, at the discretion of Banner Engineering Corp., replacement. IN NO EVENT SHALL BANNER ENGINEERING CORP. BE

LIABLE TO BUYER OR ANY OTHER PERSON OR ENTITY FOR ANY EXTRA COSTS, EXPENSES, LOSSES, LOSS OF PROFITS, OR ANY INCIDENTAL,

CONSEQUENTIAL OR SPECIAL DAMAGES RESULTING FROM ANY PRODUCT DEFECT OR FROM THE USE OR INABILITY TO USE THE PRODUCT, WHETHER

ARISING IN CONTRACT OR WARRANTY, STATUTE, TORT, STRICT LIABILITY, NEGLIGENCE, OR OTHERWISE.

Banner Engineering Corp. reserves the right to change, modify or improve the design of the product without assuming any obligations or liabilities relating to any product

previously manufactured by Banner Engineering Corp.

 

 

SureCross DX99 FlexPower Node (Metal Housing)

 

www.bannerengineering.com - Tel: +1-763-544-3164

 

Summary of Contents for DX99N9X1S2N0M2X0D2














Reviews: