6. Thread your antenna cable through a cable gland and
into the other 1/2” NPT port. Use a cable gland certified for
your region and environment. For a waterproof seal, refer
to the waterproofing instructions in Banner document
132607. (Not applicable for internal antenna models.)
When using the stainless steel antenna feedthrough (not
shown, sold separately), thread the antenna cable through
the port and thread the stainless steel antenna feedthrough
into the port. For a waterproof seal, refer to the
waterproofing instructions in Banner document 132607.
7. Connect the end of your antenna cable to the supplied
flexible antenna extension cable or to the antenna
connector on the stainless steel antenna feedthrough. (The
supplied flexible antenna extension cable remains inside the
DX99 housing.)
8. Attach the flexible antenna extension or antenna
feedthrough cable to the radio unit’s antenna connector.
(You may need to separate the space frame from the radio
to do this.) This step is not applicable for internal antenna
models.
9. Gently install the ribbon cable into the ribbon cable pins,
verifying the ribbon cable is seated on both rows of pins.
SureCross DX99 FlexPower Node (Metal Housing)
P/N 142497 Rev. L
www.bannerengineering.com - Tel: +1-763-544-3164
9
