February 02, 2024
DXM1200-X2 Controller Instruction Manual
(1)
While the file download is in process over a USB connection, do not use other applications on the PC. After the DXM reboots for a firmware update, the USB
port may be unresponsive. Clear the connection by disconnecting the USB cable and restarting the DXM Configuration Software.
© Banner Engineering Corp. All rights reserved.
74
CmVMon File
The CmVMon.txt file (Cellular milli-Volt Monitor) is created by
the system and is used to track power events. Every power-up
cycle is date/time stamped with the voltage read from the I/O
board. The value 24487 is equal to 24.487 volts. If the voltage
drops below 11.2 V, another entry is put in the log file
indicating the cellular modem will shut down.
CM
2015-09-22 18:52:43
VMon
Power entered normal
range 24487
CM
2015-10-13 20:49:47
VMon
Power entered normal
range 24004
Continued on page 74
Continued from page 73
CM
2015-10-16 15:00:20
VMon
Power entered normal
range 24014
CM
2015-10-19 19:12:26
VMon
Power entered normal
range 12845
_sxi Archive Directory
Only two types of files are moved into the archive directory:
data log files and HTTP log files. Data log files are date/time
stamped and placed into the archive directory when the size
limit is reached. HTTP log files are date/time stamped then
placed into the archive directory when they are successfully
sent to the webserver or host system. If the HTTP log files
were not successfully sent after the retries have been
exhausted, the files are placed into a root directory called sav.
Update the DXM Processor Firmware Using the DXM
Configuration Software
To update your processor firmware using the DXM Configuration Software, follow these instructions.
After the file load is completed, the DXM restarts and loads the new firmware file. It takes about 2 minutes to complete the
programming process. The device reboots when finished. Verify the firmware has been updated, under
Settings
›
General
›
Device Information
.
Clear the Password on DXM700-Bx, DXM1000-Bx, or
DXM1200-Bx Models
By default, the DXM Controllers do not require a password to load a configuration file. If a password is defined, the password
must be entered before uploading a configuration file.
To change the password, you must already know the current password. If you do not know the current password, follow these
steps to clear the password.
IMPORTANT:
Clearing the password erases the current configuration and any program files, log files, or
history files.
Using the DXM Configuration Software version 3 or later, connect to the DXM via USB
(1)
or Ethernet.
File loads to the DXM will take about 15 minutes using USB or approximately 2 minutes using Ethernet.
1.
On the configuration software, go to Settings
›
General
›
Device Information to verify the current firmware version.
You must load a different version with the same firmware number for the boot loader to operate. Download firmware
files from the Banner website.
Device Information
2.
Under Settings
›
Reprogram, click Select upgrade file to select the firmware file to program.
3.
Turn on the power to the DXM Controller.
1.
Set DIP switch 4 to the ON position.
2.
Summary of Contents for DXM1200-X2
