•
Set the Pass Count parameter. The Minimum Pass Count is the minimum number of parts, labels, or
features expected to fall within the specified criteria; the Maximum Pass Count is the maximum number
expected to fall within the specified criteria. These settings are used to determine the pass or fail result of
the inspection.
1. Set the Minimum Pass Count and Maximum Pass Count as appropriate. In the Demo, both are
set to 6, since the inspection should find six letters. The letters turn green to indicate that the
inspection passed.
5. Test the complete range of good and bad samples to make sure that the sensor accepts good parts and rejects
bad. The green check in the upper left corner indicates the inspection passed. The ROI turns green when the
sensor passed and turns red when the sensor fails.
6. To complete the Area application setup, set triggering as appropriate for the application.
NOTE: Remote Teach does not work with the Area Sensor type.
iVu Plus TG Gen2 Image Sensor
www.bannerengineering.com - Tel: 763.544.3164
63
