October 18, 2023
LC25 Pro Controller Instruction Manual
9
Chapter Contents
FCC Part 15 Class A ........................................................................................................................................................................................... 9
Industry Canada ICES-003(A)........................................................................................................................................................................... 10
LC25 Pro Controller Dimensions....................................................................................................................................................................... 10
Supply Voltage
12 V DC to 30 V DC at 30 mA maximum
Use only with a suitable Class 2 power supply (UL) or a SELV
power supply (CE)
See the WLF12 Pro Flexible LED Strip Light Instruction
Manual for the WLF12 supply voltage and current.
NOTICE: The WLF12 is designed to be
used with an LC25C and must be no
more than 3.05 m (10 ft) apart. Contact
the factory for instructions on how to use
a WLF12 without an LC25C.
WARNING: The WLF12 will be
permanently damaged if a supply
voltage of greater than 12 V DC is
applied directly to the light.
Supply Protection Circuitry
Protected against reverse polarity and transient voltages
Connections
Integral 4-pin M12 male and female quick-disconnect
connectors
Mounting
A strip of double-sided very high bonding strength tape is
supplied
Multiple bracket options available
Secure cables within 150 mm (5.9 in) of the light
Environmental Rating
IP65
,
IP67
,
IP68
Suitable for wet locations per UL 2108
Do not spray cable with a high-pressure sprayer or cable
damage will result.
Input Rating
Leakage Current Immunity: 400 µA
Indicator On/Off Response Time: 300 ms (maximum)
PWM Input Characteristics
Duty Cycle Range: 0 to 100%
Constant Frequency Range: 100 to 10000 Hz
PFM Input Characteristics
Frequency Range: 100 to 10000 Hz
Constant Duty Cycle Range: 10 to 90%
Construction
Connector Body: PVC translucent black
Coupling Material: Nickel-plated brass
Vibration and Mechanical Shock
Vibration: 10 Hz to 55 Hz, 1.0 mm peak-to-peak amplitude per
IEC 60068-2-6
Shock: 15G 11 ms duration, half sine wave per IEC
60068-2-27
Operating Temperature
–40 °C to +50 °C (–40 °F to +122 °F)
Storage Temperature:
–40 °C to +70 °C (–40 °F to +158 °F)
Certifications
Banner Engineering BV
Park Lane, Culliganlaan 2F bus 3
1831 Diegem, BELGIUM
Advanced Capabilities
Required Overcurrent Protection
WARNING: Electrical connections must
be made by qualified personnel in
accordance with local and national
electrical codes and regulations.
Overcurrent protection is required to be provided by end
product application per the supplied table.
Overcurrent protection may be provided with external fusing
or via Current Limiting, Class 2 Power Supply.
Supply wiring leads < 24 AWG shall not be spliced.
For additional product support, go
to
www.bannerengineering.com
.
Supply
Wiring
(AWG)
Required Overcurrent
Protection (A)
Supply
Wiring
(AWG)
Required Overcurrent
Protection (A)
20
5.0
26
1.0
22
3.0
28
0.8
24
1.0
30
0.5
FCC Part 15 Class A
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
LC25 Pro Controller Specifications
Chapter 3
© Banner Engineering Corp. All rights reserved.
