Banner R-GAGE Q90R, Instruction Manual

February 12, 2024

Q90R R-GAGE® Radar Sensor Instruction Manual

© Banner Engineering Corp. All rights reserved.

24

Certifications

E224071

Banner Engineering BV
Park Lane, Culliganlaan 2F bus 3
1831 Diegem, BELGIUM

Turck Banner LTD Blenheim House
Blenheim Court
Wickford, Essex SS11 8YT
GREAT BRITAIN

ETSI EN 305 550 V2.1.0

ETSI EN 305 550-1 V.1.2.1

ETSI EN 305 550-2 V.1.2.1

FCC ID: UE3Q90R

IC ID:7044A-Q90R-6

Install where not accessible by unauthorized personnel.

The device shall only be accessible for adjustment, 
programming, or maintenance.

The device was evaluated for IK08 impact energy in 
accordance with IEC 62262.

Advanced Capabilities

Output Ratings

Analog Outputs:

· Current Output (Q90R….-.I.. models): 1 kΩ maximum load resistance at 24 V; maximum load resistance = [(Vcc - 4.5)/ 
0.02 Ω]
· Voltage Output (Q90R….-.U.. models): 2.5 kΩ minimum load resistance
· Current rating

 = 50 mA maximum each

Black wire specifications per configuration

IO-Link Push/Pull

Output High

≥ Vsupply - 2.5 V

Output Low

≤ 2.5 V

PNP

Output High

≥ Vsupply - 2.5 V

Output Low

≤ 1V (loads ≤ 1 MegΩ)

NPN

Output High

≥ Vsupply - 2.5 V

Output Low

≤ 2.5 V

White wire specifications per configuration

PNP

Output High

≥ Vsupply - 2.5 V

Output Low

≤ 2.5 V (loads ≤ 70 kΩ)

NPN

Output High

≥ Vsupply - 2.5 V

Output Low

≤ 2.5 V

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed 
to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, 
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio 
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the 
interference at his own expense.

(Part 15.21) Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this 

equipment.

This device contains licence-exempt transmitters(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt 

RSS(s). Operation is subject to the following two conditions:

Cet appareil contient des émetteurs/récepteurs exemptés de licence conformes à la norme Innovation, Sciences, et Développement économique Canada. 

L’exploitation est autorisée aux deux conditions suivantes:

FCC Part 15 Class A for Intentional Radiators

6.1 

Industry Canada Statement for Intentional Radiators

6.2 

This device may not cause interference.

1. 

This device must accept any interference, including interference that may cause undesired operation of the device.

2. 

L’appareil ne doit pas produire de brouillage.

1. 

L’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

2. 

FINAL DRAFT