P/N 128185 Rev A
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
SureCross™ DX80 Quick Start Guide
23
FCC Certifi cation
The DX80 Module complies with Part 15 of the FCC rules and regulations.
FCC ID: UE300DX80-2400
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC Notices
IMPORTANT: The DX80 Modules have been certi
fi
ed by the FCC for use with other products without any further certi
fi
cation (as per FCC
section 2.1091). Changes or modi
fi
cations not expressly approved by the manufacturer could void the user’s authority to operate the
equipment.
IMPORTANT: The DX80 Modules have been certi
fi
ed for
fi
xed base station and mobile applications. If modules will be used for portable
applications, the device must undergo SAR testing.
IMPORTANT: If integrated into another product, the FCC ID label must be visible through a window on the
fi
nal device or it must be visible
when an access panel, door, or cover is easily removed. If not, a second label must be placed on the outside of the
fi
nal device that contains
the following text: Contains FCC ID: UE300DX80-2400.
Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna,
Increase the separation between the equipment and receiving module,
Connect the equipment into an outlet on a circuit different from that to which the receiving module is connected, and/or
Consult the dealer or an experienced radio/TV technician for help.
Antenna Warning WARNING: This device has been tested with Reverse Polarity SMA connectors with the antennas listed in Table 1
Appendix A. When integrated into OEM products,
fi
xed antennas require installation preventing end-users from replacing them with non-
approved antennas. Antennas not listed in the tables must be tested to comply with FCC Section 15.203 (unique antenna connectors) and
Section 15.247 (emissions).
FCC-Approved Antennas
WARNING: This equipment is approved only for mobile and base station transmitting devices. Antenna(s) used for this transmitter must be
installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any
other antenna or transmitter.
DX80 Module may be used only with Approved Antennas that have been tested with this module.
•
•
•
•
Part Number
Antenna Type
Maximum Gain
—
Integral antenna
Unity gain
BWA-2O2-C
Omni, 1/2 wave dipole, Swivel
≤
2 dBi
BWA-2O5-C
Omni, Collinear, Swivel
≤
5 dBi
BWA-2O7-C
Omni, Coaxial Sleeve, Swivel
≤
7 dBi
Table 1. Type certified Antenna
Agency Certification - 2.4 GHz
