Downloading a new
configuration
Override is active
Clean the window
Muting expired
Check the input
sequence (zone
switching)
Selectable Menu Functions include:
•
Hardware information, such as name, part number, serial number, and
firmware
version
•
Configuration
name and date, IP address, MAC address
•
Display setting to rotate 180 degrees
•
Perform a reset function
Status Indicators
The SX5 has three buttons, a graphical display, and
five
status LEDs (located below the display).
The SX5 has diagnostic LEDs for initial diagnostics. The OFF state and ON state LEDs are below the scanner's display. When it is
not possible to see the display because of the way it was mounted or because it is hidden from the operator's position, use the
software's Monitoring function to check the status.
Symbol
Meaning
1 2 3 4 5
Figure 1. Status LEDs
LED 1: Object Detection in Safety Zone (OSSD 11/12)
Red—Object detected in the Safety Zone
Green—No object is detected in the Safety Zone
LED 2: not available
LED3: Assigned to Warning Zone 2
Amber—Object detected in Warning Zone 2
OFF—No object detected in Warning Zone 2
LED 4: Assigned to Warning Zone 1
Amber—Object detected in Warning Zone 1
Off—No object detected in Warning Zone 1
LED 5: Interlock
Amber—Interlock function active (waiting for a restart signal)
Button 1: to browse quickly the Menu functions (up)
Button 2: to enter and
confirm
the selected function
Button 3: to browse quickly the Menu functions (down)
Set up the Demo Kit's Communications
The steps to change your computer's built-in Ethernet adapter or the USB-to-Ethernet converter is the same.
1. Open your PC
firewall
to allow communication between the scanner and software.
a) Look on the
firewall
for the software title "BannerGUI".
b) Edit the settings to check the boxes for DOMAIN, PRIVATE and PUBLIC.
2. Launch the SX5soft software.
SX5 Safety Scanner Demo Kit Setup Instructions
2
www.bannerengineering.com - Tel: + 1 888 373 6767
P/N 209666 Rev. A
