Installing the blade (Optional Equipment) -
Install the parts in
the following order: Holder A
– Blade Holder B. Make sure that
the blade’s direction of rotation is orientated properly before
installing the blade.
Use an “L” wrench to prevent Holder A from
spinning and tighten the blade fastening nut. The blade fastening
nut has a left hand thread. This process must be handled
carefully to prevent injury to your hands. To ensure safety, be
sure to wear gloves during the installation or removal of the
blade.
Installing the shoulder strap -
Place the shoulder band on the
shoulder. Adjust the length of the shoulder strap so that the
blade will be most parallel to the ground.
Starting and Stopping the Engine
Be sure to read the engine operation manual from proper starting, stopping, adjusting,
and other important information concerning the engine operation.
Starting;
before stating the engine, verify that the surroundings to ensure safety. Be
extremely careful during starting because depending on where the throttle lever is set, the
blade, or line head could rotate.
Stopping;
if there is no other work remaining; make sure to empty the fuel in the fuel tank.
Restart the engine and operate it until it stops. The fuel that remains in the carburetor is
consumed within 2 to 3 minutes, the engine stops. Leaving the carburetor empty of fuel in this
manner will ensure ease of starting next time.
Adjusting the Carburetor;
1. At the time of shipping, the carburetor is adjusted for optimal fuel delivery. Do not
adjust the carburetor needlessly, as it could malfunction.
2. Because the carburetor could malfunction when the engine is hot avoid prolonged
operation and allow the unit to cool ion shade.
3. Adjusting the carburetor could lead to problems. In case of any malfunction, contact
your dealer.
