Inspection Table
Items for Inspection and
Maintenance
Inspection and Maintenance Period
Before
Work
After
Work
Every 25
Hours
Every 100
hours
Inspection of cutters
*
Inspection of clamping bolts of gear
case
*
Inspection of safety guard
*
Inspection of bolts
*
Inspection of main pipe
*
*
Cleaning of gear case
*
Supply of gear case grease
*
Cleaning of clutch drum
*
Tightening of parts
*
Long Term Storage
When the working season is over and the equipment will be stored for a long time, please do
the following;
1. Clean every part sufficiently and apply a little oil over metal parts.
2. Adjust loosening clamping positions of every part.
3. Remove cutters, clean then and apply oil over both sides.
4. Remove fuel from the fuel tank, and use up fuel in the carburetor chamber.
5. Pour a little oil from the hole of the spark plug, pull the recoil starter and stop it where
compression if felt.
6. Check air cleaner, fuel strainer, etc. and clean dry and install them.
7. Keep the equipment where less humidity exists so that dust will not become attached
to it. Damage parts shall be repaired.
