Checks before Starting
Adjust the handle to a position for comfort and keeping a good balance is recommended.
Make sure that the unit is assembled properly.
If using the shoulder strap that is provided with this unit, balance the unit as recommended by
adjusting the position of the clamp on the shaft.
WARNING:
To avoid serious injury
Hold the unit down firmly so you may not lose control while
cranking. If not held down properly, the engine could pull you off
balance or swing the cutting line into an obstruction or your
body.
DO NOT cut with a dull, cracked or damaged metal blade.
Keep the unit and attachments in good working condition.
Tighten fastening parts at regular intervals. Check the cutting
head assembly before using each time.
Thoroughly inspect the area where the unit is to be used and
remove all stones, sticks, wire and other objects that could
cause injury if thrown at high speeds.
WARNING:
To avoid serious injury
NEVER
operate this unit without proper guards, shields and other safety protective
devices in place and properly connected. Inspect to determine that these safety
devices are installed properly, are in good condition and operate properly. If the
condition or operations of these devices are abnormal, they must be repaired or
replaced before using the unit.
Make sure the cutting head stops turning when the throttle lever is released and the engine
runs at idle speed.
WARNING:
To avoid serious injury
DO NOT
use any accessory or attachment other than those supplied by the
manufacturer for use with this particular unit.
