Install the Q45 Using the Disc from BWA-Q45VA-FESS and Magnetic Mount
Bracket BWA-Q45VA-CMSS
Mounting the Q45VA / VAC using these combined parts offers another mounting solution, especially if you are mounting to
aluminum or any other non-magnetic surfaces.
Follow these instructions to mount the Q45VA / VAC to the monitored asset using the disc from the
BWA-Q45VA-FESS
bracket kit
and the
BWA-Q45VA-CMSS
bracket.
1. Follow the instructions to mount the Q45VA / VAC to the BSW-BK-010 as shown in
Install the Q45VA Sensor Node Using
Magnetic Mount Bracket BWA-Q45VA-CMSS
on page 3.
2. Thoroughly clean the surface on the asset where the sensor is going to be mounted.
3. Apply Loctite 330 and 7387 Activator (or similar adhesive), according to its instructions, to the exposed clean grooved
surface of the disc.
Figure 17. Apply the adhesive to the grooved surface of the disc
4. Place the disc on the asset and press until the disc is securely attached.
5. Mount the Q45VA / VAC with the
BWA-Q45VA-CMSS
magnetic bracket already installed directly on the disc for a secure,
magnetic, mobile mounting solution.
Figure 18. Mount the -CMSS bracket to the disc
Mount or remove
Q45VA Sensor Mounting Options Quick Start Guide
©
Banner Engineering Corp. All rights reserved
