Step 2: Attatching pole to the table ( For tables from
Wausau Tile)
Step 3: Attatching umbrella frame to the pole
This step works best with two people.
1. Lift umbrella frame and place center fixture onto umbrella pole.
2. Spin frame until hole in the pole is visible.
1
3. Insert 2 / ” SS Bolt through center fixture and pole and tighten nut.
2
Remove center plug from table top:
1. Loosen the bolts underneath the table using the 9/16” socket
2. Rotate top to expose plug from underneath.
3. Tap concrete plug out of table with hammer. Leave PVC ring
in table.
Inserting pole into table:
4. Position the steel pole (the end that has the sticker goes up)
into the
center of the table.
5. The table top must now be raised about 4-6 inches from the table base. This is
where 2 helpers are necessary. While the table top is raised, the third person
positions 3 sturdy wedges. That person then positions the pole in the hole so the
drill holes becomes visible below the table top and above the table base.
6. Insert the steel pin through the hole in the pole (This is between the table top and
base) so the center of the pin is in the center of the pole.
7. Now remove the sturdy wedges, gently lower the table top to the table base so the
bolt holes in the top are positioned on the bolt holes in the base. Reinstall bolts in
table to secure top to base.
1 1 1 1 W a l n u t S t r e e t P O B o x 5 7 B a r a b o o W I 5 3 9 1 3
To l l F r e e 8 0 0 - 3 3 2 - 8 3 0 3
F a x 6 0 8 - 3 5 6 - 0 1 4 0
w w w . b a r a b o o a w n i n g . c o m
