RoadRunners Evolution –L (1D) & -LA (Laser) – Programming Guide v1.2
- 8 -
Data Capture
for Workforce
in Motion
1.2.4.
No data loss mode and Baracoda Header
Baracoda header:
It is a proprietary data encapsulation. It is necessary to activate it to use the Baracoda keyboard emulation
(Kemul) and Terminal.
The Baracoda header is enabled in default settings
No data loss mode:
Baracoda has developed a proprietary communication protocol in order to enhance the security of the
Bluetooth transmission.
Every barcode sent to the host must be acknowledged by the host (until then, the scanner will transmit it again
and again).
This acknowledgment is disabled in default settings. It is strongly recommended to set this protocol
acknowledgment on when using the scanner with the BaracodaManager.
Enable Baracoda “No Data loss mode” ON
Enable Baracoda “No Data loss mode” OFF (*)
Disable Baracoda “No data loss mode” OFF
1.3.
Reading Mode
In Trigger mode
, pressing the trigger will activate the beam.
Trigger (*)
The Aiming trigger mode
has been developed for users who need to scan barcodes very close one to another
and they have to be sure to always read the correct one. Once in this mode, in order to read a barcode user will
have to press the trigger twice. Pressing it the first time will switch on the beam but will not switch on the
decoder (thus allowing user to aim at the correct barcode) while pressing the trigger the second time will
activate the decoder thus allowing the scanner to actually decode the barcode.
Aiming Trigger Mode
