D-Fly – Programming Guide v1.2
- 5 -
Data Capture
for Workforce
in Motion
Introduction
The D-Fly barcode scanner can be programmed by scanning barcode labels which contain commands for the 1D
decoder.
Programming labels must be Code128, with specific starting and ending characters. These labels will always be
read, even if Code128 symbology is disabled.
The scanner will acknowledge a good and valid programming bar code label reading with two beeps and a
green enlightening led. It will give two other beeps (lower tone) and a red enlightening led for either an invalid
or bad reading.
Please do not read the programming barcodes while being connected to the BaracodaManager software.
Programmable options are divided into 2 groups. The first group includes the options that show the general
behaviour of the scanner. The second group sets the decoding parameters for each barcode symbology.
All our documentations
can be downloaded from the Partners download section of Baracoda website
(registration is required):
http://www.baracoda.com
