D-Fly – Programming Guide v1.2
- 7 -
Data Capture
for Workforce
in Motion
1.2.
Baracoda advanced features
1.2.1.
Switch on delay
In order to switch on the D-Fly in its standard mode, you should just press the trigger. You can set up the
scanner to be switched on only after keeping the trigger pressed for two (2) seconds by reading the
appropriate barcode.
Switch on delay : 2 seconds
\
V T \
V T z \
N U L \
S O H \
E T X \
F F \
F F
Switch on delay : 0 second (*)
1.2.2.
Shutdown timers
There are two different ‘shutdown timers’:
-
When connected timer: delay between the last scanned barcode and the switch off when the scanner
is connected to a host
-
Not connected timer: delay between the last scanned barcode and the switch off when the scanner is
not connected to any host.
It is possible to set those timers to ‘infinite’. In this case, the scanner will stay all the time ON.
Set shutdown timers to infinity
By default, timers value are:
-
When connected timer = 20 minutes
-
Not connected timer = 10 minutes
Set shutdown timers to defaults
