Baracoda Pencil2 – User Guide v1.4
- 13 -
Data Capture
for Workforce
in Motion
Configuring your scanner
There are two (2) ways to configure your scanner:
•
When connected to a host device, you can use the BaracodaManager for multiple settings (refer to
BaracodaManager documentation).
•
Or you can use configuration barcodes (refer to the Programming Guide).In this case you do not need
to be connected.
Reset your scanner:
To reset the scanner to its “default settings”, use BaracodaManager software or scan the Reset configuration
barcode (cf. Programming Guide)
Reset to factory defaults
Power management
Mutliple parameters exist to optimize the battery autonomy (“Sniff period”, “Shutdown timer”, etc…)
Pencil2 works at 10 dBm (Bluetooth Class.2).
The BaracodaManager software can be used for multiple setting changes.
Low battery
A double fast blinks red on the LED indicates that the battery level is low. Recharge batteries immediately. If
you continue using the scanner, it will continue working until a triple beep occurs: at that moment the reader
will shut down and you will be forced to charge the scanner.
Security
The Bluetooth connection is secured with a PIN code authentication.
You can configure security (enable/disable/change PIN code) through BaracodaManager and through
configuration barcodes.
The Security is enabled in default settings: default PIN code is
0000
.
All manuals and user guides at all-guides.com
