Baracuda
®
Adventura™ Robotic Pool Cleaner | Owner's Manual
Figure 27. Pull Tabs Through Each Slot
5.
Use scissors to cut the tabs at the
guides, as shown in Figure 28.
Figure 28. Stand Cleaner on its Side
6.
Repeat this procedure to replace the
second brush matt.
5.3 Replacing the Track
1.
Starting at one of the wheels, pull on the
inside of the track to separate the tire lip
from the wheel. See Figure 29. Remove
the old tyre from the cleaner.
Figure 29. Pull the Track Over Wheels to Remove
3.
Remove the old tyre. See Figure 30.
4.
To replace the tyre, position the tyre on
the wheel making sure to orient the tyre
so that the word INSIDE is toward the
body of the cleaner (Figure 30).
Figure 30. Tire Replacement Orientation
I N S I D E
Towards
Body
IN
SI
DE
INS
IDE
5.
Push one side of the tire on to the wheel
and fit the rib of the tire in the groove of
the wheel (Figure 31).
Figure 31. Start on One Side of the Tire
6.
Work the tire onto the wheel and verify
the rib of the tire is positioned properly
within the groove of the wheel
(Figure 32).
Figure 32. Work the Tire On Around the Wheel
12