Baracuda
®
Adventura™ Robotic Pool Cleaner | Owner's Manual
4.3 Start / Stop Cleaning
The factory default cleaning surface setting is
Floor and Walls
.
• Use
to change cleaning surface
setting.
•
Toggle between: Floor Only
Floor
and Walls
•
With cleaner submerged in the water,
press
to begin operation.
•
The control box will display the time
remaining for the selected cycle in hours
and minutes.
4.4 Lift System / Removal From Pool
The Lift System is designed to assist in
retrieving the robot from the pool. The Lift
System can be activated at any time during or
after a cleaning cycle.
1.
Press
on the Control Unit to
begin the automated procedure to bring the
cleaner to the wall.
NOTE: To stop the procedure at any time, press and
release the button again.
4.2 Using the Control Unit
Select Cleaning Surface
• Floor
• Floor and Walls
Start/Stop Cleaner
Operation
Lift System
Remove Cleaner
from Pool
Information LED
Cleaner Error
Indicator
2.
Next, press and HOLD to rotate the
cleaner.
3.
Once the cleaner is facing the wall of
your choice for retrieval, release the
button.
4.
Cleaner will drive forward and up the wall
it is facing. It will wait at the waterline to
be retrieved.
5.
When the cleaner is within arm's reach,
use the handle to lift it from the water
(Figure 14).
NOTE: Never lift the cleaner out of the pool by the
floating cable.
Figure 14. Lift Cleaner From Pool with Handle
6.
Hold the cleaner vertically over the pool
surface to drain water before removing
(Figure 15).
Dirty Canister
Indicator
8