3.4 Rinsing the Cleaner
Rinse the cleaner after every cleaning cycle. Use
slightly soapy clean water, then rinse generously
with clean water. Do not use solvents such as
trichlorethylene or its equivalent. Do not let your
cleaner dry in direct sunlight near the pool.
3.5 Cleaning the Filter Canister
Empty the canister as soon as the cycle ends.
WARNING
To avoid electric shock and other hazards
which could result in permanent injury or death,
disconnect (unplug) the cleaner from the power
source before performing any cleaning and
maintenance.
1.
Unplug power to the cleaner at the control
unit. Turn off power then unplug the control
unit from the power source.
2.
Release the canister handle by rotating handle
upwards (Figure 7).
Figure 7. Release Filter Canister Handle
3.3 Stopping the Cleaner
and Removing from the Pool
1.
Press Start/Stop button on control unit to
interrupt operation.
2.
When the cleaner is within arm's reach, use
the handle to lift it from the water (Figure 5).
Never lift the cleaner out of the pool by the
floating cable.
Figure 5. Lift Cleaner From Pool with Handle
3.
Hold the cleaner vertically over the pool
surface to drain water before removing
(Figure 6).
Figure 6. Drain Water from the Cleaner
Section 3. Operation
H0670800 7
