English
8
Fine Tuning Cleaner Performance
The X7 Quattro™ cycles on/off with the pool filtration pump vacuuming and cleaning all surfaces randomly
throughout the pool. The coverage of the cleaner is dependent on the pool’s shape and available water
flow. In some applications, adjustments may be necessary to optimize cleaning coverage.
A properly balanced hose will create a
45-degree angle to the cleaner and the
bottom of the pool.
In pools 8-1/2 feet or deeper, an extra
hose weight (part #W83247) may be
necessary. Attach the extra weight
5 to 8 feet from the cleaner.
A return line can be used to guide the cleaner
away from steps or areas with V-shaped corners,
and reduce patterning.
Direct the return line to gently push the cleaner
hose by positioning the return directional eyeball
so it aims towards the wall on the opposite side
of the pool. Adjust until surface movement is
visible 8 feet out from the return.
In this example, any return within the grey area
can be used.
Routine Maintenance
To maintain performance:
• Never coil the hose. Straighten a coiled hose with warm water or by laying it in the sun for a day.
A kinked or coiled hose will adversely effect the cleaner’s coverage of the pool.
• When not in the pool, keep the disc flat to avoid warping.
• Periodically inspect cleaner parts for wear. Replace the footpad when the depths of the channels
between the treads are 1/16” or less.
• Thoroughly clean the skimmer basket, pump basket and filter regularly.
• Always disconnect the cleaner from the pool wall or skimmer before cleaning or backwashing the
pool filter. After cleaning or backwashing, let the filtration system run for at least five minutes before
re-connecting the cleaner.
Correct
Balance
Incorrect
Incorrect
Operation and Maintenance
8
