Installation & Operating Instructions
|
Baracuda XA Robotic Pool Cleaner
25
Display in the
iAqualink app
(depending on the model)
Solutions
Communication
• Disconnect and reconnect the cleaner.
• Check that the cable is properly connected to
the control box.
• Check that nothing is interfering with the cable
connection area.
• If this fails to solve the problem, contact your
retailer for a full diagnosis.
Right traction
motor
Left traction motor
Right traction
motor
consumption
Left traction motor
consumption
• Check that debris or the cable is not preventing
the brushes or the tracks from rotating freely.
• Check that nothing is interfering with the cable
connection area.
• Rotate each wheel by a quarter of a turn in the
same direction until it rotates smoothly
• If this fails to solve the problem, contact your
retailer for a full diagnosis.
Cleaner out of
water
• Turn the cleaner off.
• Clean the filter thoroughly.
• Put it back in the water, shaking to release the
air bubbles.
• Restart the cycle.
• If this fails to solve the problem, please contact
your retailer for a full diagnosis.
Pump motor
consumption
• Check that no debris or hair is blocking the
impeller.
• Clean the filter thoroughly.
• If this fails to solve the problem, contact your
retailer for a full diagnosis.
Update failed or
incomplete
• Disconnect and reconnect the control box to
restart the update.
• If the error continues, contact a retailer.
Update in progress
• Wait for the update to complete.
• Do not disconnect the power cable from the
cleaner during an update.
N/A
Connection error
• Check the status of the Bluetooth/Wi-Fi LEDs on
the control box and follow the steps described in
the table “Troubleshooting the connection to the
iAquaLink™ app”
N/A
A red dot appears
in the “My Systems”
list
• Appliance not plugged in or not connected to
the home Wi-Fi network.
• If the dot is red when the control box is plugged
in and if the Bluetooth/Wi-Fi icons are lit up,
refresh the screen (by swiping downwards).
• If the dot turns green: the appliance is ready
for use.
The status indicator on the control box flashes to alert the user, follow the recommended
troubleshooting tips below. User alerts can also be accessed in the iAquaLink™ app
(on the XA4060iQ model).
2
USER ALERTS
If the problem persists, contact your retailer.
