IMPORTANT!
NEVER uncover the open end of the burner's connective piece and NEVER place it on
the ground either. Protect it by means of the special protective hood (5: Fig.5) before making the
connection. In that way, you avoid strange substances from penetrating into the appliance and from
damaging the sealings or obstructing the gas sypply.
IMPORTANT! It is strictly forbidden to make ALTERATIONS to the appliance, except in the cases
provided for by the manufacturer.
2.4 – Installing the battery for the electronic ignition of the pilot flame:
– Remove the ignition/adjustment knob (3: Fig.14).
– Unscrew and lower the ring that supports the perforated bell (3: Fig.5) and that protects the bur-
ner’s inner structure (1: Fig.14).
– Carefully lower the perforated bell + the steel cylinder.
– Find the battery holder (2: Fig.14). Unscrew the little cover and insert the 1.5V battery. Pay atten-
tion to the poles (Fig.14).
- Refit the cover and all the other parts you have previously removed.
3 – TURNING THE HEATER ON
IMPORTANT!
Remove, the protective film, if any, of the plastic parts.
IMPORTANT!
Before putting the appliance into operation, check whether the pressure regulator
and/or the pressure relieve valve and the type of gas used correspond to the data in tables 1a and
1b and to the data on the identification plate of the appliance and so comply with the regulations
that are in force in the country in which the appliance is used.
IMPORTANT!
When using LPG cylinders, take into account the dimension of the cylinder recess
(model NOMAD) (Fig.13).
DO NOT USE the heater in areas with combustible and/or explosive dust, gas damps, liquid fuels
and inflammable material.
IMPORTANT!
Repeated restarting: to avoid bursts of flame caused by gas accumulation, always
wait 1 minute before restarting the heater.
IMPORTANT!
ALWAYS fit the parabolic hood and the bell-shaped cylinder models NOMAD and
FIX) before starting the heater. DO NOT cover the parts of the burner that emit heat completely or
partially. DO NOT cover the heater shortly after turning it off. Wait until it has cooled down.
Put the heater on a flat surface to avoid it from turning over (slope < 10%). The surface must also be
non-inflammable (wooden floor, linoleum, synthetic floor, etc).
IMPORTANT! DO NOT use the heater in basements if it is pre-set to run on LPG.
WHEN YOU TURN THE HEATER ON FOR THE FIRST TIME, AN OPERATION YOU
SHOULD CARRY OUT OUTDOORS OR IN A WELL-VENTILATED ROOM, THE HEATER
WILL EMIT FUMES FOR A SHORT PERIOD OF TIME.
IMPORTANT!
Use soapy water or equivalent means to ensure that the tubings, the connections and
the quickfit of the appliance (MODELS NOMAD and FIX) are LEAKPROOF. Also check the connec-
64
B a r b e c o o k I N F R Â
