22
ACS-2048 • User’s Guide
2. Hardware Orientation
ACS-2048 Front Panel
•
3
— selects a digital DVI or analog RGBHV input (the front panel
Input 3
connector) as the source.
•
4
— selects a YUV or RGBHV input (the front panel
Input 4
connector) as the
source.
•
5
— selects a YUV or RGBHV input (the front panel
Input 5
connector) as the
source.
•
6
— selects a Composite NTSC or PAL input (the front panel
Input 6
connector)
as the source.
•
7
— selects an encoded NTSC or PAL Y/C input (the front panel
Input 7
connector) as the source.
•
8
— this input is currently not implemented.
•
TEST PAT
— selects the internal test pattern as the source.
There are two ways to use the
TEST PAT
button:
~
When
TEST PAT
is pressed, the button lights, and the internal test
pattern is routed to the output using a CUT transition. When another
input is selected, the system transitions to the new input.
~
When the
TEST PAT
button is already lit, press the
TEST PAT
button
again to toggle back to the last selected input.
In Chapter 4, refer to the “
” section on page 71 for details.
3
DVI-I
4
Analog
HD-15
5
Analog
5-BNC
6
CVBS
7
Y/C
8
Option
TEST
PAT
Note
If the
Menu Context
mode is
ON
in the
User Preference
Menu
, the
Test Patterns Menu
appears whenever the
TEST
PAT
button is pressed, allowing you to select an internal test
pattern and adjust additional test pattern parameters.
