R5976255
A
TLAS
CS4 (2001-03)
1-6
B. Power cord with ANSI 73.11 plug:
The wires of the power cord are colored in accordance with the following code:
Green/yellow:
Ground
White:
Neutral
Black:
Line (live)
!
Do not allow anything to rest on the power cord. Do not locate this product where persons will
walk on the cord.
!
To disconnect the cord, pull it out by the plug. Never pull the cord itself.
!
If an extension cord is used with this product, make sure that the total of the ampere ratings on
the products plugged into the extension cord does not exceed the extension cord ampere rating.
Also make sure that the total of all products plugged into the wall outlet does not exceed 15
amperes.
!
Never push objects of any kind into this product through cabinet slots as they may touch dan-
gerous voltage points or short out parts that could result in a risk of fire or electrical shock.
!
Never spill liquid of any kind on the product. Should any liquid or solid object fall into the
cabinet, unplug the set and have it checked by qualified service personnel before resuming op-
erations.
Warning: Do Not Place Flammable or Combustible Materials Near Projector!
BARCO products are designed and manufactured to meet the most stringent safety regulations.
Exposing flammable or combustible materials into close proximity of this device could result in
the spontaneous ignition of that material, resulting in a fire. For this reason, it is absolutely neces-
sary to leave an "exclusion zone" around all external surfaces of the projector whereby no flam-
mable or combustible materials are present. The exclusion zone must be not less than 10 cm (4").
Do not cover the projector with any material while the projector is in operation.
Keep flammable and combustible materials away from the projector at all times. Mount the pro-
jector in a well ventilated area away from sources of ignition and out of direct sun light. Never ex-
pose this product to rain or excessive moisture. In the event of fire, use sand, CO
2
, or dry powder
fire extinguishers; never use water on an electrical fire.
Always have service performed on this product by authorized BARCO service personnel. Always
insist on genuine BARCO replacement parts. Never use non-BARCO replacement parts as they
may degrade the safety of this device.
Use only the power cord supplied with your device. While appearing to be similar, other power
cords have not been safety tested at the factory and may not be used to power the projector. For a
replacement power cord, contact your dealer.
Slots and openings in the cabinet and the sides are provided for ventilation; to ensure reliable op-
eration of the device and to protect it from overheating, these openings must not be blocked or
covered. This product should never be placed near or over a radiator or heat register. This product
should not be placed in a built-in installation or enclosure unless proper ventilation is provided.
