R5976255
A
TLAS
CS4 (2001-03)
8-2
8.1 File Service
Before using a new source, a correct file has to be installed. The projector's memory contains a list
of files corresponding to the most used sources. When the new source corresponds with one of
these files, the file can be loaded and saved for future use. When there is a little difference, the file
can also be loaded and then edited until the source specs are reached.
File loading can be done automatically (see
To enter the
File Service
, handle as follows:
!
Push the cursor key
up
or
down
to highlight
'File Service'
.
!
Press
ENTER
to select.
!
The
File service menu
will be displayed.
!
EXIT
returns to the
Path selection menu
.
!
ADJUST
returns to operational mode.
The following file manipulations are possible:
Load
installation of a file for a new source
Edit
editing a loaded file to the source specs
Rename
renaming a file
Copy
copying a file to a new file
Delete
deleting an existing file
Options
way of sorting the files & automatic file loading
8.1.1 Load File
!
Push the cursor key
up
or
down
to highlight
'Load'
.
!
Press
ENTER
to select.
The
Load menu
displays the corresponding files depending on the installed filter. This filter can be
Fit
or
All
.
All
:
all files that can be loaded will be displayed.
Fit
:
only the best fitting files will be displayed (with a distinction of ± 2 lines and line duration
distinction of ± 300 ns, if nothing is found within this small area, the projector continues
searching until it finds something.)
To change the filter :
!
Push the cursor key
left
or
right
to highlight
'filter list'
.
!
Press
ENTER
to toggle the annotation between brackets.
