8. Image Menu
Image 8-25
Input black balance Red
20
0
127
Image 8-26
Change color between Red Green and Blue with <COLOR>
Image 8-27
If one uses a gray scale pattern, the bright spots should appear in the black bar.
Performing White input balance
1. Connect the source you want to project.
2. Select a white pattern (or gray scale as alternative).
3. Press
MENU
to activate the menu bar.
4. Press
→
to select the
Image
item.
5. Press
↓
to pull down the
Image
menu.
6. Use
↑
or
↓
to select
Input balance.
7. Press
→
to pull down the menu.
8. Use
↓
or
↑
to select
White balance.
9. Adjust the Red white level (gain) on a minimal value. (image 8-29)
10.Adjust the blue white level (gain) on a minimal value
Note:
This minimal value is not necessary , provided that the 2 other colors are not influencing too much the color to be adjusted,
in fact the aim is to minimize the effect of the two other colors since there is a risk of reaching too soon the transition
(bright spots) due to the contribution of these two other colors signals.
11.Adjust the Green white level (gain) until bright spots appear on the screen
12.Adjust the Blue white level (gain) until bright spots appear on the screen
13.Adjust the Red white level (gain) until bright spots appear on the screen
The projected image should now be noisy neutral grey.
68
R5976697 CINEVERSUM™ 110 06012004
Summary of Contents for CineVERSUM 110 R9010120
