79
R5900022 /18
ClickShare CS-100 series
4.
Check the check box in front of
Enable
.
The configuration fields become available.
How to configure
1.
When using the default
Engine ID
, make sure the check box before
Use default Engine ID
is checked.
The default engine ID is a combination of the Barco Enterprise Number with the MAC-address (eth0).
2.
Fill out the
SNMP Manager
address.
That is the host address which will receive the TRAP events/messages.
Possible traps can be:
•
Alarm CPU temperature trap which indicates that CPU temperature exceeds the threshold.
•
Alarm Case Fan Speed trap which indicates the case fan is spinning too slow.
•
Alarm Process Not Running trap which indicates one of the monitored processes is not running.
3.
Enter the
Username
.
4.
Enter a new password and confirm that password.
6.19 Services, Remote Button Pairing
About remote Button pairing
When using ClickShare Button Manager, a stand alone software application on your computer, you can
manage your Buttons on most of the types of ClickShare Base Units. Your computer can pair up to four
Buttons at once with a known Base Unit. It is not necessary anymore to physically connect the Button with the
Base Unit to pair it. This functionality makes it easy to use any Button with any Base Unit. Before you can use
the ClickShare Button Manager a password must be configured on each Base Unit.
How to setup
1.
Log in to the
Configurator
.
2.
Click
Wi-Fi & Network
→
Services
.
3.
Scroll to
Remote Button Pairing
.
Image 6–30 Service, Remote Button pairing
4.
Check the checkbox in front of
Enable remote Button pairing
.
Checked: remote Button pairing is activated. A password should be entered to start the remote pairing
from the Button Manager.
Not checked: remote Button pairing is deactivated.
5.
Click in the input field next to
Password
and enter a password.
6.
Click
Save changes
to apply the settings.
6.20 Security, security level
About security levels
For the use of the ClickShare system, a security level can be set. By default, level 1 is activated. A security
level is a predefined set of settings which are automatically set when a level is selected.
Summary of Contents for ClickShare CS-100
