4. CSE-800 Installation
1.
Right click on the sound icon in the system tray and select
Playback devices
. The
Sound
window opens.
2.
Select Speakers ClickShare, select
Set default
and click
Apply
.
4.9
LAN connection
For the moment, only the primary network connector can be used for API, Management Suite and Network
Integration.
About LAN connection
The Base Unit can be connected to a local network or directly to a laptop. For normal operation, a LAN connection is not necessary.
The LAN interface is split up in a primary interface and a secondary interface. During normal operation both LAN inputs have the
same functionality. During standby, the primary interface acts as an network standby and the secondary interface is than switched
off.
The LAN connection can be used:
•
to con
fi
gure your CSE-800 unit
•
to update the software
•
for maintenance purposes
•
for network integration of your CSE-800 unit
•
for network standby
C
AUTION
:
Both LAN connections must be connected to two different networks.
How to connect
1. Insert a network cable with RJ-45 connector into the primary (LAN1) and/or the secondary (LAN2) LAN port.
2. Connect the other side to a LAN.
3. Con
fi
gure the LAN interfaces, see "LAN Settings", page 45.
Note
When the primary LAN input is con
fi
gured with a manual set IP address and saved. Do not unplug the cable and plug this cable into
the secondary LAN input which is DHCP enabled. This situation will lead to a con
fl
ict as the same subnet is still associated to the
primary LAN input. The secondary LAN interface will go into fallback mode.
4.10 Power connection and switching on
W
ARNING
:
Use a power cord which complies to local regulations. If not included in the box, contact your
local dealer for a correct power cord.
How to connect
1. Plug the power cable in the mains power connector at the back of the Base Unit
Note:
The local variant of the power cable is included in the CSE-800 box.
European version
Type C and type G
Japanese version
Type A
Chinese version
Type I CCC
North American version
Type A
2. To power on the unit, set the rocker switch to “1”.
R5900049 CLICKSHARE CSE-800 19/03/2018
21
Summary of Contents for ClickShare CSE-800
