10. Maintenance
Concerned parts
R767261K
System-Power Board
Necessary tools
•
1 x Phillips Screwdriver #2
•
Hex Screwdriver
How to remove the System-Power board
1. Unplug the USB, VFD, 3RU and 1RU cables that are plugged on the top side of the board and are visible when the bottom panel
is removed. Refer to the drawing below (top side) to locate the cables.
2. With the Hex Screwdriver, remove the 5 standoffs (m 2,5 H6 Stainless Steel) which attach the CPU module to the motherboard.
Image 10-53
3. Remove the 15 screws (6-32x.31 Stainless Steel) that attach the System Power Board to the Mother board.
4. Carefully lift the board up and remove the card from the System. Don’t pull the board too far because there are still 3 cables
attached to the card.
Note:
Interposer card(s) may come out. In this case, re-install the boards into the motherboard slots unit.
5. Turn the board over and unplug the Genlock, Ethernet cable and Front panel keyboard cable. Refer to the drawing below (Bottom
side) to locate the cables.
After the system card is removed, you can also replace the System battery or the Solid-State memory. These
items can be serviced without removing the System-Power board as described in other sections of this chap-
ter.
How to install the System-Power Board
To install the System-Power Board follow the same procedure in the reverse order.
R5905948 E2 12/12/2014
247
Summary of Contents for Event Master E2
