4. Hardware orientation
4.2
Rear panel
About rear panel
The
fi
gure below illustrates the E2 rear panel.
Image 4-4
1
Two AC connectors
2
RJ-45 connector for 10/100 BaseT Ethernet communications
3
Two Genlock Input BNC with passive Loop-through
4
Two Expansion link cards
5
Eight Input cards (HDMI/DP, SDI, DVI)
6
Three Outputs cards (DVI, SDI)
7
One Multiviewer card (HDMI)
AC connectors
E2 is equipped with two redundant power supplies. During normal operation the load is shared equally by both supplies. If one
supply fails, the second carries the whole load. Two AC Connector are provided to connect the E2 to your facility’s AC power source
through the supplied power cords.
Input Power Speci
fi
cation: 100-240 VAC, 47-63 Hz
On each power supply there are 3 LED lights that provide status information as follows:
•
DC Output Power LED: when Green, the supply is outputting valid DC power.
•
Status LED: when amber indicates that an error has occurred.
•
AC Input Power LED: when green it indicates that the supply is connected to a valid AC power.
Therefore, during normal operating conditions, the input AC and Output DC LEDs will turn green.
Note that the power supplies are installed upside down, so the silkscreen markings will also appear upside
down.
Ethernet port
One RJ-45 connector is provided for 10/100BaseT Ethernet communications with the E2. The port is used for running the Web
Interface and for connection to an external device.
32
R5905948 E2 12/12/2014
Summary of Contents for Event Master E2
