1. F70 / F90-series multifunctional frame
Image 1-35
Example of
fl
oor adapter installation in landscape
Image 1-36
Example of
fl
oor adapter installation in portrait
2. Place the projector (upside down) under the truss installation and lower the truss until the support bars of the truss are nearby
the
fl
oor adapter mounted on the projector.
Image 1-37
Example of mounting to truss
3. Lock the
fl
oor adapter.
4. Install two safety cables, one on both sides of the rigging frame, and around the truss.
Mount safety cables around the frame bar (push the hook through the loop and then around the truss so that there is not to much
play (maximum 20 cm). If necessary turn the cable a few times around the truss before clasping the safety hook around the cable.
Note:
Mount the 2 safety cables in such a way that when something goes wrong, the projector cannot fall more than 20 cm. If
necessary, turn the cables a few times around the truss to obtain this maximum distance.
Image 1-38
Example of single point connection with safety cables
5. Lift up the truss with the attached projector to the desired height.
R5906768 F70 / F90 MULTIFUNCTIONAL FRAME 22/11/2017
15
