3. Lamp replacement
(e)
(d)
Image 3-4
5. Loosen two screws (f) that are securing the lamp box to be removed using a Phillips screwdriver.
2
1
(f)
(f)
Image 3-5
6. Pull the handle.
7. Pull out the lamp box by the handle while holding the projector.
Image 3-6
-
Pull the lamp box out of the projector slowly. When the lamp is broken, glass fragments may be scattering by quickly pulling
out the lamp box.
-
Do not spill liquid on the removed lamp box or do not place it near any
fl
ammable object or where children can reach to prevent
injury or
fi
re.
8. Load a new lamp box securely into the projector in the right orientation.
Image 3-7
9. Put the handle back to the original position.
Note:
Make sure that the handle is locked.
10.Tighten two screws (f) of the new lamp box tightly using a Phillips screwdriver.
2
1
(f)
(f)
Image 3-8
Note:
Make sure that the screws are tightened
fi
rmly.
11.Insert the lamp cover (e) into the projector and tighten two screws (d) on the lamp cover
fi
rmly using a Phillips screwdriver.
R5905598 PHXX SERIES 28/01/2014
13
