2. Batteries and Remote Control
2. BATTERIES AND REMOTE CONTROL
2.1
Installation of the batteries into the remote control
Read carefully the battery safety instructions, see "Important safety instructions", page 2
Necessary parts
Two size-AAA batteries (R03).
How to insert
1. Slide and remove the rear lid of the remote control.
1
3
2
Image 2-1
Batteries insertion
2. Check the polarity (+), (-) of the batteries, and set them correctly, inserting their (-) side
fi
rst.
Note:
If the battery is inserted from the (+) side
fi
rst, inserting the (-) side is dif
fi
cult because the coil spring end hits on the
battery side. If the battery is forced to insert in this way, the outer label of the battery may get ripped and it may cause a
short-circuit and heating.
3. Attach the rear lid.
Replace the 2 batteries with new ones when the remote control is slow to operate.
Removing the batteries from the remote control
Slide and remove the back lid of the remote control and take out the batteries.
R5905598 PHXX SERIES 28/01/2014
7