5-1
Controlling
5975948 RETRODATA 2100 210198
310a.DRW
5
fig.1
fig.2
RCU
CONTROLLING
Battery installation in the RCU.
A new battery (not yet installed to save the battery life) is delivered
inside the plastic bag with the power cord. Install the battery as
follows :
Remove the battery cover on the backside of the RCU by pushing
the indicated handle a little to the bottom of the RCU. Lift up the top
side of the cover at the same time (fig. 1).
Insert the new 9 V battery (type 6F22S or equivalent) in the lower
compartment and connect the battery to the contact plate.
Insert the battery into the lower compartment and put the cover
back.
Battery
Contact
plate
Behind the
plastic cover,
insert the 'card
for RCU'. You
can cut out the
insert cards in
appendix 'C' of
this manual.
Battery installation in the RCU
How to use the RCU
Projector address
Picture controls with direct access
The retro projector can be controlled with the following;
-The RCU
-The front local keyboard
-Optional hardwired RCU (cable not included)
The procedure and results of controlling the projector with either
of these RCU options or the front local keyboard is essentially the
same.
How to use your RCU
a)
Point the front of the RCU towards the picture screen. When using
the wireless remote control, make sure you are within the effective
operating distance (100ft (30m) in a straight line). The remote
control unit will not function properly if strong light strikes the sensor
window or if there are obstacles between the remote control unit
and the retro projector screen surface.
