7-1
Start up of the Adjustment Mode
5975948 RETRODATA 2100 210198
7
START UP OF THE ADJUSTMENT MODE
1. Random Access
-
Random Access should be selected if
the user selects to set up a source.
2. Installation
-
Installation should be selected when the
projector is relocated in a new configuration.
3. Service
-
Service should be selected if the user intends to
change general settings such as password, language, address,
etc. or some service actions as reset lamp run time, etc. or get
setup information.
Some items in the Adjustment mode are password protected. While
selecting such an item, the projector asks to enter your password.
Password protection is only available when the password strap on
the controller module is ON, see 'Change password' in chapter
'Service mode'.
Your password contains 4 digits.
Enter the digits with the numeric keys.
Example : 2 3 1 9
The first digit position is highlighted. Enter with the numeric keys. The
highlighted square jumps to the next position. Continue until all 4 digits
are filled in.
When your password is correct, you get access to the selected item.
When your password is wrong. The error message "Invalid pass-
word" is displayed on the screen. Press
ENTER
to continue and to
return to the Service menu.
Factory programmed password :
0 0 0 0
Once the password is correctly entered, all other password pro-
tected items are accessible without re-entering your password.
When re-entering the Adjustment mode, it will be necessary to enter
your password again when selecting a password protected item.
ENTER PASSWORD
----
Use numeric keys
<EXIT> to return
PASSWORD
Error
Invalid password
<EXIT> to return
Adjustment Mode
All source set ups, picture tuning and geometry are made while in the
'Adjustment mode' . Press the
ADJUST
or
ENTER
key to enter the
'Adjustment mode'.
You are now in the 'Adjustment mode'. The control disc (RCU) or '+
or '-' keys (local key panel) are used to make menu selections and also
for adjustments. The
ENTER
and
EXIT
keys are used to move forward
and backward through the menu structure. The
ADJUST
key can be
used to terminate the adjustment mode while any path selection menu
is displayed.
There are 3 possible paths to follow once in the Adjustment mode.
They are :
ADJUSTMENT MODE
Select a path from below :
RANDOM ACCESS
INSTALLATION
SERVICE
Source 01
Select with
ê
or
é
then <ENTER>
<EXIT> to return.
Adjustment Mode
Guided Adjustment Mode
