1. TLD HB (1.6-2.0:1) Lens Kit
How to install the new lens?
To install the lens, follow the next procedure:
1. Take the lens assembly out of its packing material and remove the lens caps on both sides.
2. Move the handle (A) of the lens anchor system to the right. (image 1-4)
3. Push the lens, motors at the top, in the lens block gap horizontally, lining up the motor connector on the lens with the connector
on the lens block (B), until the lens clicks in the lens anchor system.
Caution:
For a table mounted projector, hold the projector when pushing the lens into the lens block to avoid sliding off from
the table.
Image 1-4
Lens installation
1.4 Quick Lens Adjustment
Quick zoom/focus adjustment
1. Press the Selection key
*
, Barco key.
The zoom/focus menu will be displayed. (image 1-5)
2. Push the cursor key
↑
or
↓
to zoom and
←
or
→
to focus the image.
3. When finished, press
EXIT
key to return or
ENTER
to continue to the shift adjustment.
LENS ADJUSTMENT ZOOM/FOCUS
ZOOM with or ,
FOCUS with or
<ENTER> to shift
<EXIT> to return
Image 1-5
R5976663 TLD HB (1.6-2.0:1) LENS KIT 14102003
5
