28
5
Using the remote control
PAUSE will function normally;
pressing any other buttons will
not access the OSD Menu.
8.
AUTO IMAGE
This button is used to Resync the
image; when the image signal
becomes unstable or image
quality deteriorates simply press
this button and the projector will
automatically adjust the screen
dimension, phase, timing and so
forth.(The adjustments also apply
to PIP input).
CONTRAST
Adjust the level of white in the
image to increase or decrease
image contrast.
BRIGHTNESS
Adjust the level of black in the
image to increase or decrease
image brightness.
SHARPNESS
Adjust image sharpness and
clarity.
PHASE
When the image flickers, doubles,
distorts or appears to be wavy,
press this button to adjust.
COLOR
Adjust the image’s color saturation
When oversaturated, the colors in
the image will appear to be very
bright and vivid; on the other hand,
if colors are undersaturated, the
image will appear to be washed
out.
TINT
This button only works for video
signals input through the Video
and S-video ports. By pressing
this button, you can adjust the
ratio of magenta and green in the
image; lowering this setting will
make the image appear more
magenta, while increasing this
setting will make the image
appear more green.
PIP
PIP
Use this button to display or
disable PIP.
SWAP
SWAP
Use this button to switch the
sources of image PIP display.
ADDRESS
ADDRESS
*Only 2 addresses are possible*
Press and hold the
ENTER
buton
and press this button until the
remote control panel flashes once
(approximately 5 seconds) to
change the receiving address of
the remote control. If you use one
remote control to operate two
different projectors, you can
assign different address for the
two projectors so that when you
operate projector A, projector B
will not be affected.
