Barco Thor Series Installation Manual Download

Page: 73 / 182

R5906788-03

Thor series

Functionality of the buttons

Numeric buttons (No.1 - 6)

Each Numeric button (reference

Image 8-4) can be linked to a macro which allows you to setup the

projector to your requirements with one push of a button. The backlight of the Numeric button is white if a
macro is associated with the Numeric button. The backlight is green if the macro associated with the
Numeric button is activated. The backlight is red in case one of the actions of the macro failed. Inactive
Numeric buttons have no backlight.
When the authorization process is activated with the (security) Key button, the backlight of the Numeric
buttons changes to yellow.

Marker area

Each Numeric button has a marker area (reference

Image 8-4) where you can write down the name of

the Macro.

Standby button

Pushing the Standby button (reference

Image 8-4) for 3 seconds changes the projector mode from

Standby mode (energy saving) to Operational mode or vice versa. The backlight of the Standby button is
blinking white or green, depending on the requested mode. Once the requested mode is reached the
backlight will be continuously lit up green in Operational mode or white in Standby mode.
Enter or leave Standby mode can also be done via a 2 dedicated projector command (USB/Ethernet), or
via two predefined Macros (not editable) with GPIO, or via the Communicator.
During projector initialization the backlight of the Standby button is blinking blue.
In case the Light button and the Standby button continuous lights up red indicates that no lens is
installed or that the ambient temperature inside the Light Processor compartment is exceeded or that the
DMD FRONT or DMD BACK temperature is exceeded.

Star button

Star button (reference

Image 8-4). Pressing the Star button a few seconds will activate the ICMP reset

process.

Light button

Light button (reference

Image 8-4) switches the lasers ON or OFF.

Pushing the Light button (reference 5 Image 8-4) for 3 seconds will activate or deactivate the lasers of
the projector. The backlight of the Light button is blinking white or green, depending on the requested
mode. Once the requested mode is reached the backlight will be continuously lit up green when the
lasers are activated or white when the lasers are deactivated.
In case the Light button and the Standby button continuous lights up red indicates that no lens is
installed or that the ambient temperature inside the Light Processor compartment is exceeded or that the
DMD FRONT or DMD BACK temperature is exceeded.

Focus button

The Focus button (reference

Image 8-4) allows you to focus the projected image on the screen. The

backlight of the Focus button is red in case the end of range is reached.
In case no lens (file) is selected the Focus button remains inactive. No backlight.

Shift button

The Shift button (reference

Image 8-4) allows you to shift the lens up/down or left/right. The backlight

of the Shift button is red in case the end of range is reached.
In case no lens (file) is selected the Shift button remains inactive. No backlight.

Dowser button

The Dowser button (reference

Image 8-4) opens or closes the dowser. The backlight of the Dowser

button is green when the dowser is requested to open and white when the dowser is closed. Red
indicates an error.

Input & Communication