5. Covers
5. COVERS
About this chapter
This chapter explains the removal and installation of chiller covers in detail. The removal of chiller covers is required to gain access
to the chiller components during the maintenance and servicing procedures.
W
ARNING
:
Make sure that you switch off power and lock the switch of the chiller prior to removing or in-
stalling any chiller cover. See "Switching off power and locking the switch", page 15.
Overview
•
•
5.1
Removing a cover
Overview
All covers can be removed in a manner similar to the following procedure, where the left cover is removed.
Due to the high amount of screws holding each cover to the chiller, it is advised to use an electric screwdriver.
Necessary tools
Allen wrench 3 mm
How to remove a cover?
1. Remove the 14 screws (reference 1 image 5-1) from the cover.
1
1
1
1
1
1
1
1
1
1
1
1
1
1
Image 5-1
Removing 14 screws
2. Remove the cover.
R5906015 ULC-30A 01/02/2018
17
Summary of Contents for ULC-30A
