12
4.3.2
The gap sensor detection; print debugging mode and enter the value of
Self testing
This measurement is used to determine the sensitivity of the label paper sensor
after the printer is turned on. When the user replacement of different
specifications of the roll or the printer will initialize the set values for the restore
factory settings, namely the need to re label paper determination of gap sensor.
To detect the gap or black marker is in accordance with the correction of the last
time you set value. The default value of this printer sensor is set to the gap
correction.
Please follow the steps below to make the calibration of the label paper
：
1. Please make sure that the label paper is properly installed
2. Power off the printer
3. Press the key to open the printer power supply
4. In the first light purple, blue and purple, flashing, release the feed key
Indicator color cycle mode
：
Blue and purple Blue Blue and purple Red(flashing 5 times) Blue
and purple(flashing 5 times) Blue(flashing 5 times) Blue(fixed)
5. The sensor will do to correct the label paper, and print from the
measured value, the last into the debug mode and print out the numerical
6. Please turn off the computer again, so that the printer returns to the
normal print mode
Caution:
Before making the label paper sensor calibration, use the Diagnostic Tool or
the GAP command to confirm the type of tag to be detected
；
More instruction
information about GAP
，
Please refer to
XPL programming manual(
Instruction
set manual
)
