84
SECTION 6: IBUTTON FUNCTIONALITY AND REGISTRATION.
The IButton is provided to enhance security on the MPU6 Horizon cabinet and no other
IButton can be used as it needs to be registered with the machine before it can be used.
However any IButton can be used for refill if the machine is set to non security mode.
The IButton Cell replaces the functionality of the following switches.
•
Hopper Top up.
•
Secondary Test.
•
Refill.
•
Hopper Dump.
The new MPU6 IButton configuration and registration in the event of a misplaced IButton is
given in the following sections.
6.1 IButton
Functionality
This section explains the functionality of each of the IButton’s as well as the steps required to
register an IButton if one is misplaced.
The three IButton Cells functionality is explained in the sections below.
6.1.1 Hopper Top Up and Secondary Test Switch
This receptor is located to the right left hand side of the coin mech unit and the IButton is
secured onto a length of chain to the rear of the cabinet to ensure that it does not get lost.
To top the hopper up offer the IButton to the receptor in door open mode and when correct
contact has been established an audio prompt of Hopper Top up will sound to confirm the
action has been completed. At this point the hopper will be topped up to its maximum float
capacity.
To enter the test routine using the IButton, press the MPU6 enter button and the LCD will
display a “Confirm Test Mode” message.
Now present the Button to the same receptor used for the hopper top up and once the
correct contact has been established an audio prompt of TEST” will sound to confirm that the
test menu is now available.
6.1.2 Hopper Top up/Secondary IButton Registration
To register a replacement Hopper/Top up IButton, then follow the instructions given in this
section.
Select the up and down buttons on the MPU6 together for several seconds then offer up the
replacement IButton onto the receptor port. This key will now be registered and ready for
use as described in section 6.1.1.