Manual 2100-701
Page
6 of 16
BASIC FIELD INSTALLATION
1. Unpack the ventilator assembly which includes the
integral ventilator with attached electrical harness
and miscellaneous hardware.
2. Disconnect unit power.
3. Remove the existing exterior blower access, filter
access and vent option panels on the wall mount
unit (see Figure 1). Save the blower access and
filter access panels and discard the vent option
panel.
Model
For Use with the
Following Units
Electrical
ERV-FA2
W18AB-A
W24AB-A, -B
W18HB-A
W24HB-A, -B
230/208V
1 or 3 phase
ERV-FC2
W24AB-C
W24HB-C
460V
3 phase
ERV-FA3
W30AB-A, -B
W36AB-A, -B
W30HB-A, -B
W36HB-A, -B
230/208V
1 or 3 phase
ERV-FC3
W30AB-C
W36AB-C
W30HB-C
W36HB-C
460ERV-F
3 phase
Be sure the correct model and voltage
energy recovery ventilator is used with
the correct air conditioner or heat pump to
ensure correct voltage compatibility.
!
CAUTION
!
WARNING
Open and lock unit disconnect switch
before installing this accessory to prevent
injury or death due to electrical shock or
contact with moving parts. Turn thermostat
to OFF.
FIGURE 1
Remove Access Panels
BLOWER ACCESS
PANEL
FILTER ACCESS PANEL
VENT OPTION PANEL
TABLE 1
Model Reference
